Now showing 1 - 10 of 12
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Numerical simulation of airflow around buildings
    (Leykam, 2015-11-26)
    ;
    ;
    ;
    Dragosits, T. 
      259  1061
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Thermally Activated Building Structures as Flexibility Option for the Electricity Market
    (TIB Open Publishing, 2024-04-22)
    Preßmair, Guntram
    ;
    Amann, Wolfgang
    ;
    Stipsits, Alina
    ;
    Schoisengeier, Sama
    ;
      2
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
      1  259
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Numerical and experimental characterization of a novel low-cost thermal air flow sensor
    (IEEE, 2017)
    ;
    ;
    Glatzl, Thomas 
    ;
    Sauter, Thilo 
    To enable highly efficient operation of large scaled ventilation systems a continuous measured and well located air flow monitoring for control purposes and energy management is needed. The air flow monitoring solution is targeting low manufacturing cost as well as sufficient accuracy when operating near complex duct flows like pipe bends and tees. Therefore, a novel, low-cost, thermal air flow sensor, which takes non-uniform velocity profiles into account, is presented and characterized due to its application in heating, ventilation and air conditioning systems. Extensive numerical simulations and experimental investigations in an operating ventilation system show reasonable results and prove basic feasibility of the suggested novel sensor concept.
      2Scopus© Citations 3  112
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Exponential pattern recognition for deriving air change rates from CO2 data
    (Institute of Electrical and Electronics Engineers (IEEE), 2017)
    ;
    ;
    ;
    Mateis, Cristinel 
    ;
    Dejan, Nickovic 
    A novel procedure for automated determination of air change rates from measured indoor CO2 concentrations is proposed. The suggested approach builds upon a new algorithm to detect exponential build-up and decay patterns in CO2 concentration time series. The feasibility of the concept is proved with a test run on synthetic data that shows a good reproduction of the previously defined air change distribution. The demonstration continues with test runs on CO2 datasets measured in the kitchen and the sleeping room of two residential buildings. The derived air change rates were within the expected distributions and ranges in both cases when natural or mechanical ventilation was used.
    Scopus© Citations 3  300  668
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Getting Fit for the Future: Optimizing Energy Usage in Existing Buildings by Adding Non-Invasive Sensor Networks
    (IEEE, 2018-08)
    Sauter, Thilo 
    ;
    Treytl, Albert 
    ;
    Diwold, Konrad 
    ;
    Molnar, David 
    ;
    Lechner, Daniel 
    Optimizing energy usage is becoming an economic necessity for existing buildings. Non-invasive sensors and sensor networks are key technologies for efficiently achieving this goal, since it is of utmost importance that existing hydraulic systems are not changed and the engineering effort for installation remains minimal. This paper presents a data-driven approach that should allow low-cost installation of sensors at arbitrary points of the building and then retrieve the structure of the hydraulic system from the recorded sensor values. The architecture as well as first preliminary results from field test buildings are presented.
      1Scopus© Citations 1  420
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    SOFC-Systemlösungen für Wohngebäude
    (Leykam, 2017-11)
    ;
    ;
    ;
      87  297
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Towards non-invasive temperature measurements in HVAC: A characterization and correction approach
    (IEEE, 2019-06)
    ;
    ;
    ;
    ;
    Sauter, Thilo 
    The existing building stock within the European Union is responsible for a considerably huge amount of the total energy consumed. This has prompted legislative actions that focus on increasing the efficiency of Heating, Ventilation and Air Conditioning facilities by employing building automation and electronic monitoring systems. The fluid flow temperature in the hydraulic grid of a building is therefore an essential parameter to be measured, where clamp-on temperature sensors are often applied due to their simple and cost-effective installation. As the plumbing industry heads towards non-metal pipe materials with low thermal conductivity, the applicability of non- invasive measurement procedures diminishes. In this context, a characterization approach of non-invasive temperature measurements that is linked to a thermal resistance model is experimentally validated. Based on that, a correction algorithm to reduce the deviation between measured surface and the fluid flow temperature for steady state conditions is derived and tested. The presented approach provides sufficient characterization and correction performance, albeit several limitations have to be taken into consideration.
      1Scopus© Citations 1  442
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
    Characterization of non-invasive pipe flow temperature measurement
    (2017-10)
    ;
    Derler, Bernhard
    ;
    Seidl, Christian
    ;
      3  31
  • Thumbnail Image
    Some of the metrics are blocked by your 
    Item type:Publication,
      149  376